CR-10 S5 Stand Alone Mod

thingiverse

This is my setup for a CR-10 S5 Stand Alone Mod. I loved the idea of a stand-alone CR10. I found one but everything was exposed under the bed, so this remix moves all components into boxes on rails. Creality silent board with 40mm fan for control box plus an upgraded mosfet. I used the power box and remixed the cover to fit my fan. Added extra holes for wires in the case and removed the hole for the second aviation plug since my setup only had one for the hotend. I directly wired the bed to the new mosfet and ran new wires to the power supply. I used a mountable mosfet box from www.thingiverse.com/thing:2976220. For using the S4 or S5 screen, you'll need this case by JackyBoyII at www.thingiverse.com/thing:4325299. I upgraded my screen with one that has a built-in SD card reader, using Jsschlat files for the case at https://www.thingiverse.com/thing:4230727. Also, I upgraded to direct drive using the printermods direct drive kit. I'm using this top mount spool holder with filament detector by s_gutz. You'll need an extension cable or make a set to use this setup at www.thingiverse.com/thing:2830892. You'll also need these additional parts: Flat LCD 10 Pin Ribbon cable, 50cm https://www.amazon.ca/gp/product/B01BI009A6/ref=ya_st_dp_summary?ie=UTF8&psc=1 12 to 16 Gauge wire - I went with 12 which was overkill; 14 or 16 might be better. I got 20ft (10ft each) at https://www.amazon.ca/gp/product/B0769FCLB4/ref=oh_aui_detailpage_o04_s00?ie=UTF8&th=1 5x M4x8 Hex Cap Nuts https://www.amazon.ca/gp/product/B01N68EESR/ref=oh_aui_detailpage_o05_s00?ie=UTF8&psc=1 5x M4 TNut https://www.amazon.ca/gp/product/B01FOC6ADE/ref=oh_aui_detailpage_o05_s00?ie=UTF8&psc=1 -19x 14 Gauge Connectors and 1 14 Gauge Crimp https://www.amazon.ca/Assorted-Terminal-Insulated-Electrical-Connector/dp/B01MAW05S0/ref=sr_1_3?ie=UTF8&qid=1521086942&sr=8-3&keywords=terminals