CR-10(S) E3D Titan Direct Drive Extruder Mount for V6 adaption

thingiverse

For using this Redex Titan Clone on CR-10S: https://www.amazon.de/gp/product/B07L9JJ7XJ/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&psc=1 I need to make some adjustments to the base plate because of a larger gearbox. Additionally, I want to modify my 12mm ABL Sensor and install a second fan for better airflow. Thanks a lot for this brilliant original design that makes modifications extremely easy. Settings: - To use the small NEMA17 motor with its original cables, you must swap the wires in the middle (2<>3) on the Motor Plug (6 pol.). 1 23 4 > 1 32 4 - Furthermore, you need to invert the direction pin in the firmware, also with the delivered cable. - ABL Offset (mm): X/Y 60/3 - The Redex comes equipped with a 1.8° step angle NEMA17 motor, which means 200 steps. Given that most stock boards use 16 microsteps, you should adjust your extruder settings accordingly. The default setting may be around ~425 steps/mm or ~0.002355 mm/step. Note: If it's your first attempt at direct extrusion, you might want to decrease print speed and acceleration on the X-axis because there is more weight on the sleigh than before. Bugfix01: Mounts of 2ndFan too long -> chopped Update: There is also a drag chain available on Thingiverse: https://www.thingiverse.com/thing:3787999 Update: A clip for mounting a heatsink without tape but with thermal transfer paste has been added, along with some fixes. Update: BL-Touch (v3.1) mount has been integrated.