CR-10 Rear Switch Mounts (3D Chameleon)

thingiverse

This print is specifically designed for the Quad color option by 3D Chameleon. To install it, simply flip one tab over and slot the hole approximately 1/8" deep. Next, bolt the switches to the part using standard 3mm hardware. The print will register perfectly in the track when slid all the way back, where it will be securely held in place by a T-Slot nut. For best results, it's recommended that you slot the hole outside of the bracket. Using a 1/8" drill bit or slightly larger, carefully create the hole and then drag the drill sideways while it is still spinning to prevent damage to the circuit board. You can find more information about the multi-color adapter on the official website at 3D Chameleon: https://www.3dchameleon.com.