CR-10 Mod - Frame Braces

cults3d

My Customized Braces for the CR-10/CR-10S Frame My printer is a CR-10 with the dual Z motor kit, plus belt and pulleys on top to prevent loss of synchronization between the two screws. I had to leave some space free for installation and adjusting the pulleys on the upper brackets. In my case, I can reach the full 400mm Z stroke without any interference, but at the top, I have very low clearance at 400mm stroke (~2 mm), so be aware of this. The top bracket uses OEM hardware (screws, T-nuts, bearings, and bearing covers), while the bottom one requires three screws and three t-nuts each. I needed two M8 threaded bars, 640mm long, and ten M8 nuts to complete the setup. Everything was printed and installed successfully. Everything fit perfectly, except for the nut covers, which I secured with a small amount of silicone to keep them in place. Thanks to everyone who helped me with this project!