CR-10 Mini Semi Auto Leveling G-Code

thingiverse

Download and run the CR-10 Mini Semi Auto Leveling Code.gcode file. Be prepared with your paper, ready to place it at each corner before the printer reaches Z0. This semi-auto leveling procedure is designed specifically for the Creality CR-10 Mini. The process will begin by homing the printer, then move to all four corners and wait 15 seconds while you make adjustments to each leveling wheel using your test gauge paper. The printer will signal three beeps before each move, ensuring your safety. Three quick beeps indicate that the procedure is complete. Before running this semi-auto leveling procedure, it's recommended to heat the bed. However, the G-code has heat disabled by default; uncomment it if you want to use heat before leveling. The printer will wait for the bed temperature to reach the set point before continuing. A helpful tip: If you ever remove the cover from the controller, apply a few layers of tape over the speaker hole to significantly reduce the squeal of the beeps. Warning: Your bed should already be very close to level before running this procedure. This semi-auto leveling routine is intended for quick tune-ups of an already manually leveled bed.