CR-10 MAX light holder arm

thingiverse

This is a light holder for CR10 MAX. It clamps onto the gantry supports, and has hand-adjusted knob for light pitch. I made it bit too massive, so it should be able to hold a horse (not tested that though, before you set off to get a horse). The light attached turned out to be a bit ... light ... so the strength was entirely unnecessary. It is attached on the picture to two CR10s, but you can just as well attach it to a single one. If you put right at the top of the braces, your bed/print will be unobstructed.For assembly, you'll need two M8x60 screws and nuts for the thumb screws, four M6x40 screws with round heads with nuts, and two M6x50 screws for payload. All nuts have melt-in slots so that they are flush. You can add a bit of electricians tape to the clamps to add some friction, but since it it is aluminum, you can go into town tightening it so it holds just fine.