CR-10 Legs and Electronics Box Legs

thingiverse

I designed two sets of legs to elevate the CR-10 without needing to remove its existing feet. One set is for printers without end caps, and I had to make a new pair because I lost some on my original. The V2 set, however, is tailored specifically for CR-10 printers with endcaps. I also created a set of legs for the electronics box. I printed each CR-10 leg one at a time, standing upright with a brim and support, while the electronics box legs were printed sideways with supports touching the build plate or no supports at all. At 20% infill and a 2mm wall thickness, each leg requires only 56 grams of filament. The electronics box legs, on the other hand, use an impressive 54 grams of filament each.