CR-10 IKEA LACK floating flush controller mount with scraper holder

thingiverse

My Version of a Mount for the CR-10S Controller to an IKEA LACK Table. I deliberately chose not to drill holes into the side or top of the table, as most mounts available require this, and I wanted the controller to sit flush with the surface. The end stops are not included in the bracket model, which would result in either a poor-quality top surface or an excessive amount of supports for the 3-millimeter high end stop. Therefore, I designed them separately and attached them using CA glue. I've provided an end stop that also serves as a holder for the scraper. The brackets feature four screw holes each, but you will only need to use two of these. I secured my bracket by using opposing screw holes and kept the other two in reserve in case I made a mistake during mounting. These extra holes allowed me to tap into unthreaded wood if needed. You can opt for all four screws for added rigidity; I used random 3mm diameter wood screws that I had lying around. Since I'm not utilizing the stock spool holder on my controller, I only needed to support the weight of the device itself. Twenty percent infill proved sufficient for this purpose, but I wouldn't recommend going below this level. The Fusion 360 project file and a .step file are included with this design.