CR 10 Feet (uses foam from packaging)

thingiverse

This Creality CR-10 Foot Design uses the foam packaging material that came with the CR-10. The feet replace the existing rubber bumpers and use the same screws as before. Using this design, my printer is now much quieter because it's isolated from the desk. I didn't think replacing the feet would make a big difference in noise, but it really did. To install these feet, simply swap out the old rubber foot for this new part, and then insert the piece of foam after cutting it to size. The foam that came with my CR-10 had the following dimensions: - Length: 300mm - Width: 44mm - Depth: 32mm To make these feet work, you'll need to cut the foam into four pieces, each about 50mm long. *Note: This design only uses the original foot plate - just remove the rubber foot and replace it with this new one!