CR-10 Feet Supports

thingiverse

I bought some [Ikea drawers](https://www.ikea.com/us/en/p/nordli-3-drawer-chest-anthracite-s49384134/) based on incorrect measurements for my CR-10S and it ended up being too short to fit my machine safely. It was close, though, so I designed some supports that I could screw into the back to properly fit it. Not only does it support the machine, but it also prevents it from sliding around and falling off the drawers. It's quite sturdy, and I was unable to break them by hand when loaded in the correct orientation. My CR-10S has been converted to be [all-in-one](https://www.thingiverse.com/thing:3513661), so the feet dimensions are probably different than a stock CR-10S. Additionally, there is no control box that needs space to the side. It screws in with #8 1/2" wood screws to assemble the back supports and to screw into the drawers. There is one with a flat back, and one with offsets to match the edges of the drawers on each side.