CR-10 Fan Mod 0.8mm Shorter v2 (Reinforced Screw Mounts)

thingiverse

This is a minor revision to Gabriel3DCaster's Creality CR-10 Fan Mod 0.8mm shorter. My original fan duct broke at the screw mounts. When I ran Gabriel3DCaster's, I broke the fan mounts again just while cleaning it up after pulling off the printer. I decided to add a little extra reinforcement to the outside of these screw mounts as additional insurance. If you find this helpful, please give it a like. By all means, please give Gabriel3DCaster a like and a tip for his efforts in designing the original. If you haven't been able to find exactly what you need, again, check Gabriel3DCaster's page as he has a few renditions of this fan duct. Gabriel3DCaste https://www.thingiverse.com/thing:2814127 Below are the settings that Gabriel3DCaster recommended in his original version of this fan mod. Print Settings Printer brand: Creality Printer: CR-10 Rafts: No Supports: No Resolution: 0.1 mm Infill: 10% Notes: This part has small details so it is better to print it with an high resolution (0.1mm works well). I recommend you to use a brim to avoid warping.