CR-10 Easy Snap-on Universal Bed Mount

thingiverse

# Easy Snap-on Universal Bed Mount for CR-10 I had a stash of old mounts that didn't work for my CR-10, along with failed prints from trying them. Many of these custom mounts took up the same mounting space, making it impossible to use them together. As a videographer, I have a large collection of generic 1/4 - 20 adapters/mounts that are cheap and do the same thing as custom mounts. I also strive to make things modular with simple roles as a software architect. I hate disassembling my printer to install something because it adds time and complexity. ### The Solution So, a universal mount was needed that was easy to print and install. This thing is my solution. Large bed leveling knobs are compatible (check the pictures for reference). Just add a small washer between the knob and the bed if space is needed. ### Additional Information #### Alignment This print is wide by nature, so make sure it's centered or even left justified to stay within the CR-10's bounds. #### Infill I used 20% infill in the piece shown. It's very strong and more sturdy than other mounts. You could probably get away with only 10% infill. #### For the Front of the Bed Only! This doesn't work on the rear of the bed because the heated bed wire support bracket is in the way, and the Y motor is also in the way. I didn't see a need for side rails, but I added small through holes at the ends of the sides to allow them if someone wants. ### Mount Adapter Already have a mount printed that attaches around the leveling screw you want to keep? Check out the mount adapter I added.