CR-10 Dual LED Strip Mount (Snap-in)

thingiverse

I wasn't impressed with any of the LED mounts/holders out there, so I took matters into my own hands and came up with a custom solution. This mount securely holds two strips of LEDs beneath the top bar and clicks into place without needing any extra parts - just glue in your LED strips and you're good to go! I used two 5630 LED strips and the result is incredibly bright. Check it out: https://www.amazon.com/gp/product/B01339G2F6 The mount features a gap on either side towards the back for effortless wire routing. To take it to the next level, you can add a layer of aluminum foil on the inside to reflect more light - I cut two strips and used double-sided tape to secure them in place. It's not essential, but it definitely makes a difference. I also got creative with my CR-10 by zip-tying a switch to the top for convenient on/off control, and routed the wires down the back using pieces of the plastic/rubber strips that come with the printer.