CR-10 DTI Bed Leveling Mount

thingiverse

For swift and precise bed calibration. An adapter for the DTI to be installed "AS CLOSE AS POSSIBLE TO THE NOZZLE." I employed the Neoteck DTI Digital Dial Indicator (Purchased from Ebay). The rod diameter is 8mm. You will need to drill a hole of diameter = 10mm in the fan hood at the position shown in the corresponding image. Secure a magnet on top of the mount to ensure stability during bed calibration. I utilized these two powerful magnets extracted from a damaged hard drive, but any other magnets would suffice. The benefits of this design: 1- The DTI tip is extremely close to the nozzle 2- You don't have to apply force on the mount and fan hood to remove it after bed calibration, which may cause misalignment of the z-axis Although the design is very straightforward, it is remarkably stable and efficient. I also added a hole cover to seal the hole after bed calibration The printing settings can be seen in two images