Cr-10 Dial Indicator mount

thingiverse

I printed the original one but unfortunately, it didn't fit my Dial Indicator quite right, and to be honest, I wasn't too thrilled with those tiny contact points between the shroud and mounting point, especially considering they were layered on top of each other. So, I beefed up the design a bit more, adjusted the mount sizes to match my indicator's specifications, and added some chamfers for good measure - after all, why not make it look sharp? My Dial Indicator can be found here: https://www.amazon.com/gp/product/B01G9K7KCK/ref=ppx_yo_dt_b_asin_title_o00__o00_s00?ie=UTF8&psc=1 I just used a bolt with a wingnut since that was all I had on hand, and as it turns out, I don't leave the mount in place for extended periods of time. In this case, using a locknut seems like overkill.