CR-10_Dial_indicator

thingiverse

I began with a decent model from DanRayol, but it was quite tight-fitting and incomplete. I made the dial gauge fit better and expanded the clearance for the part cooling fan air exit. I also removed most of the back. Furthermore, I changed the screw holes to M8 and added two more for holding the dial from above. This design prints with fewer supports and is approximately 15% lighter. If you print it exactly to size, the screws might be overkill - the fit on the fan shroud is snug, and a 70mm dial gauge is also fairly tight. It works well as is, but I may make some additional refinements to it. In the pictures, it's printed with Amazon Basics Orange PLA.