CR-10 / CR-10s Frame Brace 2.0

thingiverse

Brown, I've noticed a flaw in my previous frame brace design. When the nozzle reaches 37 cm in height and is positioned completely left or right, it clashes with all-thread screws using the stock nozzle or larger setup. To rectify this issue, I've reimagined the frame braces from scratch, adopting a new approach. This revised design requires fewer materials, less print time, maintains durability, and widens thread spacing by 8 cm. If only I had detected it earlier when designing the original frame. Better late than never, after all. To build these enhanced frame braces, you'll need: 2 x M10 all-thread screws (63.5cm long) 8 x M10 hex nuts 8 x M5 x 8mm long screws (up to 10mm may work as well) 8 x M5 T-nuts 4 x printed parts If you prefer using M8 threaded rods, consider incorporating jellyfinger's spacers: https://www.thingiverse.com/thing:3265904