Cr-10/Cr-10s/Ender-3 MR16 light holders/caps

thingiverse

I Made These Mr16 Led Light Holders For My Cr-10s, But They Worked Perfectly On My Ender-3. I Simply Snapped Them On To The Cr-10s Without Any Issues. However, On The Ender-3, They Were A Bit Tight And Required Filing The Clip Edges To Get Them To Fit Properly. A Few Drops Of Super Glue Held The Lights In Place, While The Caps Slipped Over The Exposed Wires That I Had Soldered On Earlier. I Used 120v Mr16 Led Lights From Home Depot For This Project, Along With Some 18ga 2-Wire Cord That Has No Polarity. I Wired It To A Light Switch And Placed It In A Conduit Box. I Will Be Posting Pictures Of The Final Result Soon.