CR-10 / CR-10s Dual Extruder Dual Oiler

thingiverse

I experienced frequent filament jams on my TH3d dual extruder with hot end setup from TH3D for my CR-10s. Tim recommended adding an oiler, which worked effectively, but the downloadable version designed for a single extruder was not ideal. To resolve this issue, I attached the oiler via the two screws holding the Z axis in place and a through bolt for the tab underneath. Please note that you will need to acquire a 10mm longer bolt than the one included in the TH3D kit or similar dual extruder setups. Once printed, insert some lightly oiled cotton wool into the guides and pass the filament through. This solution proved to be effortless, with the added benefit of keeping the filament away from the Z axis screw. I've made both an STL file and a STEP format file available for immediate printing (which works perfectly) or modification/improvement. If you make any adjustments, kindly share them by linking back to me so I can review your version.