CR-10 / CR-10s bed / glass clip system

thingiverse

This model is designed to secure the cork insulation of a table (3 mm thick), as well as glass or mirrors (4 mm thick). The design aims to minimize interference with the nozzle, fans, and table sensor. A device for correcting the zero along the Z axis may be required in this case, such as one found on Thingiverse (https://www.thingiverse.com/thing:2531282), or a level sensor must be used to automatically adjust the table. If standard table springs are utilized, they can exert pressure on the model and insulation, necessitating the use of durable materials like PETG. However, PETG and ABS may still be compressed by these springs. To prevent this issue, shorter springs should be substituted or the table raised along the Z axis to reduce spring pressure on the model. When using a level sensor, 13-14 mm spacers (similar to those found at https://www.thingiverse.com/thing:3034629) can replace standard springs; their length can be adjusted in a slicer. The material selection for clips also depends on the working temperatures of the table. For temperatures between 70-75 degrees C, PETG is suitable, but if the temperature exceeds 80 degrees, ABS or another heat-resistant material should be chosen to prevent clip deformation under heat.