CR-10/CR-10S Bed Cable Support

thingiverse

Just unwrapped my CR-10S a week ago and was worried the hot bed cable might snag on the rear left corner of the frame. Scoured the web for supports specifically designed for CR-10/CR-10S hot bed cables but couldn't find any I liked. New to 3D printing and modeling so decided to give designing my own a shot with FreeCAD. A YouTube video on FreeCAD was incredibly helpful. Worked through three iterations (first one too short, second didn't have rear support and the third is the current design). Very straightforward design, no supports needed to print it out, 0.2mm layer height and 20% infill. Used M4 screws and T-nuts to secure it to the frame. The holes in the current design need to be drilled slightly larger (if I make any changes later on, I'll enlarge them). I have the CR-10S and at some point, I'd love to add blue racing stripes like one poster did with the squash feet and capture layer heights. Think that would look cool. Would require 4 color transitions (black to blue, blue to black, black to blue and finally blue to black). Looking forward to hearing your thoughts on this!