CR-10 Control Stacker (Works also with Wanhao Dup i3,Malyan M150 and Monoprice Select)

thingiverse

Hi, I've designed this Stacker Stand for my 2 Cr-10 printers. I wanted to limit their space usage and make use of the extra Creality Controller extension wires from a kit. This design allows you to stack up to 3 or 4 controllers securely. You can also adapt it for other similar controllers on various printers, such as the Wanhao, Malyan, and Monoprice. Here's how to build this Stacker Stand: 1- Print two stands at your preferred infill setting; I used 15% with my chosen filament. 2- Apply some dollar store antiskid rubber mats to both faces of each stand using contact cement. Cut them out and trim the excess with a sharp utility knife after gluing. 3- Drill 10mm holes for wooden dowels, allowing you to connect two stands into one solid unit. I used three 200mm dowels and two 50mm dowels; the extra space was needed to avoid clearance issues with USB and SD ports. I secured the dowels using Gorilla glue, sourced from the art section at a dollar store along with the dowels themselves (3/8" or 9mm in size). I finished them off with electrical black tape and darkened the ends with a sharpie.