CR-10 Control Box Stabilizer

thingiverse

I prefer to locate my spool holder off to the left, away from the printer's wires, for easier access. However, when a full 1kg spool is loaded onto it, the control box tends to tip over until some filament has been used up. To counteract this, you can place a heavy object on top of the box. I opted to design this stabilizer to eliminate the problem altogether. Simply slide it onto the rear of the control box, being careful not to cover the rubber feet and screws. This fits my control box snugly, but results may vary depending on different settings and filaments. This stabilizer should also work with the CR-10 S4, and likely the S5 as well, although I haven't had a chance to verify this on the S5 model.