CR-10 Bed Leveling Wedge

thingiverse

I no longer own a CR-10S, so I won't be making any updates to these files. This CR-10S bed leveling wedge installs on the Y-carriage and under the insulation for the bed heater. It's adjustable from 13mm to 14mm and designed for a 3mm X 40mm Lg screw with a 3mm hex nut. I recommend printing Part B flat and Part A on its side to avoid interlocking layers during use. I installed two of these wedges, one in the front and one in the back, and my heated bed has a valley down the center. Since my bed runs low, I prefer higher spring tension to keep it from getting out of adjustment. To achieve this, I used an adjustable z-stop bracket (https://www.thingiverse.com/thing:2158261) and ran it all the way down. I also use a DIY magnetic flexible build plate (https://www.thingiverse.com/thing:2788007) instead of glass, which prevents parts from getting stuck to the bed and makes it easier to remove them without knocking it out of level. Although I considered revising this design for better user-friendliness, I haven't done so yet. I also thought about adding height spacers to accommodate different setups, but that didn't happen either - I sold my printer. If this doesn't work for you, you might try https://www.thingiverse.com/thing:2168244, which is taller.