CR-10 Bed Clip for 12" glass

thingiverse

Liked the original design, but found that it wouldn't fit my 12" glass bed without interfering with the Z-axis. So I remixed the clips to be smaller and thinner.\r\n\r\nUpdate:\r\nDiscovered that the clips didn't hold the bed securely enough and would eventually slip off during a print, causing a failed job. To fix this issue, I created an anchored design that not only keeps the bed in place but also provides protection against the spring digging into the heated bed. Depending on your printer's tolerances, you might still need one alligator clip to keep the bed completely solid, but now it has no chance of sliding off. This clip should be printed sideways and doesn't require any support material.\r\n\r\nI highly recommend using three of the anchored bed clips and one Strain Relief Corner clip for optimal results.