CowTech Ciclop 3D Scanner

thingiverse

Human: Finalized Parts Now Ready for Download! CowTech Ciclop is a redesigned version of the BQ Ciclop, optimized to print parts in half the time and use 2/3 less filament than before. This means you can print these parts on nearly any printer, regardless of size. Funded by Kickstarter, this project raised an impressive $183,800 from over 1400 backers. Now available for pre-order at www.cowtechengineering.com, you'll need two each of the laser core, laser holder, and pattern holder to get started. Both PLA and ABS filament work perfectly well. Here are all the parts you'll need: Laser Cut Parts with All Sizes in Inches: 1x Top T: 0.220 inches 1x Bottom T: 0.220 inches 1x Faceplate: 0.220 inches 1x Turntable: 0.220/0.236 inches 1x Frosted: 0.062/0.125 inches (if you don't have frosted acrylic, lightly raster the surface) 1x Pattern: 0.062 inches 3x Wire Holder: 0.220 inches 2x Laser Arm: 0.220 inches Some preview images may look a bit funky, but rest assured they'll download accurately. Print Settings: Printer Brand: RepRap Printer: Prusa i3 Rafts: No Supports: Yes Resolution: 0.2mm Infill: 10% Notes: Camera Base: Support everywhere, no platform adhesion needed. Motor base: Support everywhere, no platform adhesion needed. Camera Holder: No support, no platform adhesion. Backplate: Support everywhere, no platform adhesion needed (print standing up with flat side down). Laser Holder: Support everywhere, no platform adhesion needed. Bearing Holder: No Support, no platform adhesion. Laser Holder Core: No Support, brim or raft suggested. Gear: No Support needed, brim or raft suggested. Note: Printing orientations may not match the suggested orientation.