Covid Roomba HEPA Mask

thingiverse

Mask was crafted using SemiFlex and the container was fabricated in PLA. BEFORE DOWNLOADING >>> Please review the full license. This is a free model, and you can distribute it freely and modify it as needed. But you must give proper credit and may not use it for commercial purposes (absolutely no exceptions). Finally, if you remix/modify it, you must distribute your contributions under the same license as the original. If you find this model elsewhere and somehow breaks any of the stated license conditions you can send us a message so we can take suitable measures. Mask and original model can be found here https://www.thingiverse.com/thing:4225667 BEFORE PRINTING >>> We recommend to do a fine calibration of your printer before starting printing the mask and its components. Check your horizontal expansion to ensure your pieces will fit properly (tutorial) This 3D model has not been approved by any regulatory agency and has not passed any laboratory tests. It is a prototype designed by LAFACTORIA3D (a Spain-based company), presented among many other works in the CORONAVIRUSMAKERS community, created with the aim of providing emergency protective material to medical professionals who need it, given the current global shortage of supplies. It is not intended to replace any certified mask, but to provide minimal protection. We cannot guarantee its operation, so use it at your own risk. Print Settings Rafts: Doesn't Matter Supports: No Resolution: 0.2mm Infill: 20% Filament_brand: WYZWORKS, SEMIFLEX Filament_material: PLA / SEMIFLEX Notes: Print the mask and components with only two walls (with a line width of 0.4mm each). In CURA, disable "Print Thin Walls" to decrease printing time avoiding unnecessary infills between the mask walls. I Included the mask from the original source but there were no changes made to it. I Only created the container to hold the roomba 700 HEPA filter.