COVID Face mask gap filler

thingiverse

I designed this to stop my eye glasses steaming up when wearing a Covid 19 face mask. It fills the gap between the arch of your nose bridge and cheeks to stop breath escaping out of the top of your paper or cloth mask. It attaches to your mask using magnets inserted in to the filler and magnets glued to tabs outside of the mask. Designed to be printed in flexible TPE, rubber like plastic. It is flexible and a little bit spongy to conform to the shape of your face. Depending on the stiffness of your particular TPE filament print at 5% infill and one or two outer shells. Requires two 8mm Diameter by 3mm and two 8mm diameter x 1mm Rare earth magnets. Glue the 3mm deep magnets into the filler and the 1mm deep magnets into the tabs being careful to ensure the magnets are correctly orientated to attract to each other.