COVID blaster 99.99%

thingiverse

There should be a "Yes-ish" option for supports. I designed and perfected this under the influence of alcohol. I'm writing this while intoxicated on booze. Nailed it. Print this thing however you want, it's still going to work well and keep you from getting sick. Realistically, 0.2 layer height worked perfectly for all parts. (If you're not using Cura, I don't know your software so figure it out) Print the body thread or "muzzle" up with supports from the build plate only. If you select "everywhere," you will mess everything up. The trigger should be printed on its side. Because efficiency. It's faster this way. Print it on its side with supports everywhere. Mint. BTW, enable support interface, stop hurting yourself. Print the thing in any way you want. But you'd be an idiot if you printed it without the chamfered end up. You'll have to chuck it up in a drill and give it a nice concentric point (rounded or not) with sandpaper or something abrasive. You'll need a pen spring by the way, which pushes on the thing. ASSEMBLY: 1: Pull the end off the hand sanitizer bottle; there's no picture of that part anywhere. Get rid of it, or keep it. Your choice. 2: Unscrew the pump apparatus from the bottle. 3: Realize steps 1 and 2 could be reversed. 4: If you haven't printed everything yet, you should have done so already. 5: Fill the reservoir with life-saving hand sanitizer. 6: Drop the thing into the tube-shaped hole orifice the pump handle left. Then put the spring on top of it. 7: Push the end of the pump apparatus into the trigger; you may have to sand the outside diameter (OD) of the plastic and motivate it with some pliers. I designed it like this for fun. 8: I'm having another beer, which is a lot of steps. 9: Make sure the trigger slides into the rail easily. If it doesn't, sand it where needed. Also, a little oil helps it slide along. 10: Test fire with the muzzle pointed up. 11: If it didn't work, you did something wrong. 12: If it did shoot life-saving hand sanitizer, proceed to step 13 13: Shout "HAIL MOST BEAUTIFUL AND OMNIPOTENT FLIMFLAMMACHINE" By the way, you might have to prime it by firing upwards before dispensing life-saving hand sanitizer.