Covers for the CTC Large top corner holes

thingiverse

The custom cover designed for the "Large" CTC edges proved too small for the Dual CTC printer. I fabricated new covers to fit the larger printer accurately. Measuring each of the three triangles from a single corner of the Large CTC, I discovered that their sides are precisely 3.0 centimeters long. To ensure stability, I attached pins strategically across the edges. To achieve a clean finish on the front cover, I carefully incorporated overhangs that match the curves of the printer's edges exactly. In contrast, the rear section lacks these overhangs to allow for the complete installation of the printer's hood at the top. Print Settings Printer: CTC Large Rafts: Disabled Supports: Enabled Resolution: 0.2 millimeters Infill: Fifteen Percent