Cover to install a Noctua fan NF 6*25 on a Meanwell RSP-320-24

prusaprinters

The RPS-320-24 is delivering a lot of power, but the original fan was just too noisy. So I choose a Low noise fan NF 6*25. But due to his width of 25mm, it must be installed outside of the original frame, so I designed a new cover to install it. This new cover is fitting the RSP-320-24, with the "Supply Cover" from https://www.thingiverse.com/thing:2863826. Not tested for LRS-320-24 or other "Supply Covers", but some of them may be compatible. Print instructionsJust print : Meanwell cover Fan protection Fan grid . I used PETG, but not sure this was needed. Be carefull to place some supports to print the cover, as the 2 areas fitting inside the "Supply Cover", need them. I used 3*M3x18mm screws to fix the fan protection to the cover.