Cover for a solderless 9 pin D-Sub connector

thingiverse

The cover fits a solderless 9-pin D-Sub connector as shown in the accompanying photos. It prints in two separate halves with no need for supports during printing. However, identifying a suitable screw to mechanically link these halves can be quite challenging. At this moment, it is not feasible to directly attach the covered D-Sub connector to an assembled unit that requires screws because the connector holes are inaccessible from the rear, leading to only push fittings being possible. The cover's design ensures easy access to crimping screws and wiring openings without requiring users to detach these two printed halves.