Cost saving version of Ciclop

thingiverse

I remixed the great Ciclop design into a cost and time-saving version for those who print it themselves. The key improvements are: - No need for bearings, only Ø6 mm ball spheres. This is based on the design from http://www.thingiverse.com/thing:1454048 - No need for M8 rods - The amount of PLA needed for the camera and motor support has been decreased. - Camera and motor support feet have been modified to work with 8mm wood rods. - A 4mm header (6mm long) is required, screwed through a hole in the motor support using a key. The shaft and round support are now one piece, which is 5mm lower than the original. However, this has no impact on scans from my experience. To save material, I reduced the diameter to 10cm instead of 20cm. A 20cm disc can be placed above if needed. Printed in PLA at 200C/55C using an Alunar M508.