Cosplay Mask, Hat and Wig Stand V2

thingiverse

This is a mask, hat, and wig holder. The design focuses on simplicity and rapid production. In this remix, I've separated the components so that they can be printed on a 220 x 220 build plate at full scale or on a 200 x 200 build plate at 95% capacity. Conversely, the V2 prototype was too large for my Batman helmet, which is why I probably should have scaled down to 95%. The parts fit together with a snug interference fit but can be glued for added security. Printing Guidelines: 1. The holder was printed quickly using an 0.8mm nozzle, 0.6mm layer height, and @40mms speed. One perimeter wall and 7% infill were used. 2. Additional speed reductions may be achieved by only printing the bottom layers and relying on the infill for stability. Average print time at these settings was approximately 35 minutes.