Cortana Chip Halo 4 - Half Edition Remix

myminifactory

I took a Remix from Samg381's original Thingiverse File (http://www.thingiverse.com/thing:515833). After printing the entire thing out, I discovered that one side was not up to par, so I cut the Chip in half and printed both sides separately for a smooth finish. To replicate this process, you'll need to duplicate the Chip in your slicing software (Cura or whatever you're using) and mirror it to either the left or right side. Since there's only one half included in the file, this step is essential. Additionally, make sure to print the Chip flat on its side, rotating it 90° for optimal results. To achieve the best outcome, use a layer thickness of 0.05mm or 0.1mm and infill your prints at a rate of 10-15%.