Corsair Fan Snap Grommet Replacement SP120 AF120

thingiverse

This is a replacement part designed specifically for Corsair 120 mm fans SP120 and AF 120 models, which I purchased in 2013 - possibly the same design has been retained since then. The original fans come equipped with a rubber grommet that deteriorates over time due to aging or being subjected to excessive pressure, causing it to crumble or break off completely. These replacement grommets fit seamlessly into place of the original rubber ones, allowing for proper mounting while maintaining compatibility with most fan screw types and hole spacing configurations. I printed this part using ABS at a 0.2 mm layer height and 4 perimeter settings for added strength. Increasing the number of perimeters enhances the overall strength of the part and allows for machining of the hole if a larger screw is required. After printing, it should fit into place quite easily; however, if it's too small, simply reprinting it slightly larger will resolve the issue. Otherwise, you can sand it to achieve a better fit.