Corner Twist Cover for Cordmate II Conduit

thingiverse

This is a custom connector for Legrand brand Cordmate 2 low-voltage cable organizing conduit/raceway, I designed for an overhead projector setup with surface mounted wire management down to ground level It allows the conduit to twist on its axis while also turning 90 degrees to the right. This is to avoid having to wreck the ceiling finish with the conduit's adhesive backing A hole is included for a #8 screw, so it may be secured into the wall, so the adhesive on the ceiling section doesn't have to be used. This assumes the other end, near the projector in my case, is supported as well. The conduit is rigid enough that it won't slump over a short section like this