Corner Shelf

A fully customizable, 3D printable corner shelf, for interior or exterior angle corners.
This design allows you to choose the radius, angle, thickness and amount of bevel.
You can also customize the size and position of the screw holes, as well as the orientation for printing.
This design is*completely free* and shared under a permissive license. Your support is hugely appreciated.
Did you know?
Some of our designs cannot be found on Thingiverse. If you are looking for more, check out our premium projects:
https://codeandmake.com/premium
OpenSCAD Customizer Options
We recommend you use OpenSCAD to customize this design.
This design has the following Customizer options:
Shelf

Shelf_Radius - Radius of the shelf
Shelf_Angle - Angle covered by the shelf
Shelf_Thickness - Thickness of the shelf
Bevel_Percentage - Amount of bevel as a percentage
Bracket_Thickness - Thickness of the bracket
Arms - Number of arm supports
Arm_Length_Percentage - Length of arm supports as a percentage

Screws

Screw_Holes_Per_Bracket - Number of screw holes per bracket
Screw_Hole_Shift_Percent - Amount to shift screw holes towards the outside as a percentage
Screw_Hole_Padding - Amount to pad each screw hole
Screw_Hole_Diameter - Diameter of the screw hole
Screw_Head_Diameter - Diameter of the screw head
Screw_Head_Countersink_Angle - Screw countersink angle (82 and 90 are common)

Print Orientation

Print_Orientation - Orientate for optimum printing

Design Considerations
In many cases, it should be possible to print designs without supports.
Add arms to improve support, but ensure they do not prevent you from accessing the screw holes. You may need to adjust the number of Arms, the Arm_Length_Percentage, the Screw_Holes_Per_Bracket and/or Screw_Hole_Shift_Percent.
Material
We recommend a durable filament, such as ABS, for this design.
Versions

1.1 (23 Feb 2022) - Small correction to header comment
1.0 (2 Feb 2022) - Initial version

Printing
Recommended slicer settings:

Resolution: 0.1mm - 0.2mm
Infill: ~20% - 80% depending on desired strength.
Supports: Should not be required for most designs.
Rafts: Not required, unless you experience adhesion issues.

License
The "Corner Shelf" models (.stl) are licensed under the CC BY license by Code and Make.
The "Corner Shelf" code (.scad) is licensed under The MIT License by Code and Make.
Note: 'BSD' license has been selected as it is the closest available option in the list.
We are proud to offer content to you absolutely free.
We love to create free content for you. As you might imagine, it takes a lot of time. Supporters help us fund materials and equipment to create future projects and tutorials. To show your appreciation, please use the link below:
https://codeandmake.com/support
We thank you so much for your support!


Category: DIY