Corner Shelf for Work Area

thingiverse

Update 2020-10-16: My original print of this started to come apart at the seams (likely due in part to the breakneck speed at which it was printed), so I took advantage of the situation to make some enhancements. I strengthened the mounting tabs so they're less likely to snap now, and also dug deeper grooves because I found that parts still tended to roll around. I also countersunk the screw holes so the screws won't have to stick out anymore. Just a straightforward shelf for a conveniently located corner in my garage. It has some grooves in it to keep screws and other small round parts from rolling away. I believe the pictured print was done at 125 mm/s, .28 layer height, and 10% infill. It didn't turn out perfectly, but it works just fine. Higher quality could presumably be achieved with more conservative settings. Be cautious when screwing in the mounting tabs. I expect they're fairly fragile and wouldn't hold up to a screw being driven in hard. Also, bear in mind that this completely filled the bed on my Ender 3 Pro, so I couldn't use a skirt/brim/raft for adhesion. It still printed just fine though.