Corner Leg for 2020 extrusion - 120mm

thingiverse

I looked all over the internet for corner legs that fit 2020 extrusions. Do you think I could find them? No. There's plenty for 2040, not many for 2020. Anyway, this is my take on them. These will raise your machine 120mm and are attached with (2) M3x16 machine screws and hammer nuts. I can't guarantee they will fit all 2020 extrusions, but they should fit the common type (like found on the ADIMLab Gantry). To keep the legs from moving around on the table, I smeared a thin layer of hot-melt glue to the bottom and let it cool. I've found this provided enough friction to keep the machine from sliding all over the place. Be sure to post a make if you decide to use these. I'd love to see it!