Corner Leg for 2020 extrusion - 120mm

prusaprinters

<p>I looked all over the internet for corner legs that fit 2020 extrusions. Do you think I could find them? No. There's plenty for 2040, not many for 2020. Anyway, this is my take on them.</p><p>These will raise your machine 120mm and are attached with (2) M3x16 machine screws and hammer nuts. I can't guarantee they will fit all 2020 extrusions, but they should fit the common type (like found on the ADIMLab Gantry).</p><p>To keep the legs from moving around on the table, I smeared a thin layer of hot-melt glue to the bottom and let it cool. I've found this provided enough friction to keep the machine from sliding all over the place.</p><p>Be sure to post a make if you decide to use these. I'd love to see it!</p><h3>Print Settings</h3><p><strong>Printer: </strong>ADIMLab Gantry</p><p><strong>Rafts: </strong>No</p><p><strong>Supports: </strong>No</p><p><strong>Resolution: </strong>any</p><p><strong>Infill: </strong>25% Cubic (min.)</p><p><strong>Filament:</strong> Any&nbsp;<br>&nbsp;</p><p><strong>Notes:&nbsp;</strong></p><p>I recommend printing them "standing up" as shown in the stl.</p><p>You'll need to drill the holes out to remove the thin layer of plastic where the big hole meets the little hole.</p><p>&nbsp;</p><p>&nbsp;</p><p>&nbsp;</p><p>Category: 3D Printer Parts</p>