Corner Clamp

thingiverse

Test.stl before printing the entire thing! I made a test print with the thread horizontal and it works fine, but you should still test it yourself using Test.stl and screwing them together. In my case, it was a bit tricky, but after some rotation, it worked. If you can't get it to work, try pouring a little hot water over it several times, but be careful not to melt it. I printed it at 75% of the original dimensions. I used supports with roofs and a distance of 0.2 mm to the top and 0.3 mm sideways. I printed with an infill rate of 20-30% Gyroid. Four perimeters give the structure more stability than a higher infill rate. If you like my work, a small tip is much appreciated!