Corner/Ceiling Mount for Fibaro Multisensor 2

thingiverse

I adapted the inner diameter of the "hole" for the motion sensor to come out the right size on my printer.\r\n\r\nTry printing a few layers and then check if your sensor fits into the opening at the base of the holder. If not, simply adjust the size of the holder in your slicer and try again. But don't be too generous with enlarging, it has to be a tight fit or the sensor will fall out.\r\n\r\nFor horizontal installation at the ceiling, the sensor stays in place by gravity alone, but if you use it vertically, it's a good idea to stuff some tissue paper behind it (it doesn't hurt for horizontal installation either) to keep it in place.\r\n\r\nThe plug is meant to cover the screw hole.\r\nIf you print the plug, be aware that you'll need to shrink it - it probably won't fit into the hole as it is. I haven't tried it yet, but if I do, I'll replace the STL with one of a fitting size.