Corgi Phone Stand

prusaprinters

GeneralInspired by a few of the phone stands available out there I wanted one that I can easily grab my phone off of, with or without a charging cable attached but had some uniqueness factor to it. Corgis are cool and so with this available model, I was able to come up with this phone stand. Use either double sided tape or nano suction adhesive (what I recommend) to keep it on your desk.Phone Stand PropertiesLarger openings to support bulkier cases or larger phonesExtra back support should allow for portrait and landscape orientationExtra gap from where the phone stands to the base should allow for larger sized charging cablesPrintingI printed this on a 0.4mm nozzle using PLA at 0.2mm layer height. I used a standard cubic infill at 15% and it feels pretty solid. There's two ways you can print this in regards to overhangs, you can either add supports OR (what I recommend) use the Cura Experimental option Make Overhang Printable. I used the default settings for it but you can mess with the overhang angle setting to get your desired outcome. While it changes the model a little bit, you don't really notice the changes (specifically under the ears, by the tongue and the tail) and you'll save some filament not printing supports.