Core A8 45° Brace - 25.4mm

thingiverse

PRINTING INSTRUCTIONS ------------------------------------------ Face-down printing is recommended. Supports are not required as the most severe angle of print is only 45 degrees. If you choose to print the round version of the clamp, it can be printed vertically without supports. ABOUT --------------------------------------------- An angled brace designed for the Core A8 that addresses wibbly wobble issues. This accessory is compatible with the large clamp from the original Core A8 setup. I successfully printed and installed this on my machine, achieving great results. In fact, it's slightly over-engineered, but it gets the job done. This design comes in three sizes: 25.4 mm, 20 mm (which has been corrected), and 25 mm variants, as well as a special round version measuring 24 mm that was requested by another user.