Cord Manager

thingiverse

This entire design is made to help organize your cords at your desk. You can screw it down into the desk at the four corners of the print. The cord managers themselves spin in place to help give you the most efficient cord managing possible. Just to add on and make this design even more useful, it has a divot/pocket that has the exact measurement of the largest phone currently out just to make sure all phones can be used! The platform has a hole through the middle of it in which you can take a drill bit the exact size or even larger than the hole and drill a hole through the desk to allow the Cord Manager to be put to use! ------------------------------------------------------------------------------------------------------------------------ (Use Washers on top of screws to help hold in place) ------------------------------------------------------------------------------------------------------------------------ This was a very tough learning experience for me mainly because I have never used any connectors or unique parts too help pieces spin and move. But mainly since 3D printing is so limitless, these hardships were very doable to overcome and get through. If there was one thing though I would do different, I would make it even harder on myself and make the cord holders slide all aro8nhjd the platform in a square like shape and allow them to lock in place when you found a spot you'd like to keep them at.