Cord / Cable Holder - FolgerTech - Prusa I3

thingiverse

I needed something to hold my cabling tight, so I used an M4 screw and bolt setup that I had on hand. You have to tighten the screws all the way down or the holder will slide, but if you do it'll stay put. Will this work for your printer? To be honest, I'm not entirely sure. The gap is 52mm by 15mm, and the little lips stick out about 2mm. It took me around an hour to print at .2 resolution. Here are my print settings: I used a RepRap printer, specifically a Prusa i3 model. Rafts didn't make a difference in this case. Supports also weren't necessary. I set the resolution to .2 and went with 20% infill.