Coolermaster Elite 130 Front Mount PSU Bracket

thingiverse

The power supply used had a prominent top where the fan grill was located, which likely contributed to some of the issues with it not fitting properly and all that. I'm unsure about getting a permanent link to the Tinkercad model. This design allows for the front mounting of the power supply on the Coolermaster Elite 130 case; however, you need to drill out the 5.25" bay on top unless you plan to use an SFX power supply or something. The original used in the picture and a version with a slightly larger "Top" are included, hopefully addressing shrinking issues as the original is slightly forced into place. It was extended by .25mm in all directions and the holes were made slightly larger. Print as shown in the Cura screenshot; add a support blocker to everywhere but the front in your software. Still relatively new to 3D printing in general, I think I could have skeletonized the block the PSU sits on more effectively actually.