Cooled Full Housing for GekkoScience USB Miner (Compac F)

thingiverse

From my tutorial "Running a solar-powered Bitcoin/Lightning Node & Lottery Miner" on Medium: https://medium.com/@ne0nblack/running-a-solar-powered-bitcoin-lightning-node-lottery-miner-introduction-12005bd06960 Full Housing for GekkoScience USB Miner with a 40 x 10 Fan. Toolless assembly - snap and press fit. Requires high accuracy with 0,1 mm layer height through a 0,2 mm nozzle when using FDM. Recommended Fan Sunon MF40100V1-1000U-A99 FITTING If you printed with the recommended settings, you should find some dots in the vertical direction. These clamp the PCB vertically. Should you have problems closing the housings, you can sand them down. Due to the close proximity of the components of the PCB to the edge, it is clamped in prism shaped rails. Should the fitment be to tight, you can file them down. ASSEMBLY 1. Slide the PCB through the opening of the bottom upper housing (marked "B") with the USB connector first. The Heatsink facing front. 2. Close the upper housing with the top part (marked "T") until it clicks in place. Make adjustments if necessary. 3. Insert the fan from the front, while observing the blowing direction marked on the housing and the cables facing the respective slot. The label usually faces inward. 4. Secure the fan with the front endplate (marked "F"). 5. Slide the USB connector of the PCB through the opening in the rear part of the lower housing (marked "R"). Leave some room between the lower and upper housings. 6. Mate the lower housing rear and front (marked "F") together until it clicks in place. 7. Slide the lower housing completely into the upper housing. 8. Secure the lower housing to the upper housing with the rear endplate (marked "R"). Tip me: ne0nblack@getalby.com