Cool Top

pinshape

Printing on my Ender 3 has been an adventure with this particular top. I've had mixed results, but one thing stands out - the printer itself was often the culprit behind the print failing. Half the time, the nozzle would knock off the support material before it could even finish printing. And when that happened, I'd end up with a half-finished top stuck to the surrounding material, which was a nightmare to remove. But here's the thing - too much support material made it nearly impossible to get off without damaging the print, and not enough made it prone to getting knocked loose by the nozzle. So, it's a delicate balance. If you're planning on trying this top out, be prepared for some trial and error. It may take a few attempts to get it right, but with patience and practice, you'll get there.